Carter AccuRight Table Inserts for Band Saws – Pack of 3

Description

Carter AccuRight Table Inserts for Band Saws – Pack of 3

You can make bandsaw cuts that are virtually tearout-free on the exit side of your work thanks to these nylon zero-clearance throat plates.Simply saw a narrow kerf partway through the plate, slide it around the blade into your saw’s throat opening, and go to work. Your blades’ flexibility means that zero-clearance plates will eventually get chewed up, so the plates are sold in packs of three for ready replacement when needed.

Pack of 3

Specifications

The fit recommendations below are general guidelines.
PLEASE MEASURE YOUR INSERT TO BE SURE YOU ARE ORDERING THE CORRECT ONE.

ID1000 Specifications

• Diameter:2-1/2″
• Center thickness:5/32″
• Thickness at edge:7/64″
• Rabbet width:5/32″
• 1/8″ x 1/16″ rounded tab on left-hand side at 9 o’clock
• This inserts fits most Delta 14″ Cast Iron Bandsaws and clones including the Steel City 14″.

IJ1000 Specifications

• Diameter:2-1/2″
• Center thickness:5/32″
• Thickness at edge:7/64″
• Rabbet width:3/8″
• 1/8″ x 1/16″ rounded notch on left-hand side at 9 o’clock
• This insert fits some Jet 14″ Cast Iron Bandsaws and clones. It also fits some Jet 12″, & 18″ band saws.